Keep your unfinished work

This page has edited values. Stay to save them before continuing. A tab draft is separate from saved Project evidence.

WorkspaceProjectsTeamsWork Modes

Quick checks work without a Project. Save important results explicitly.

Choose the context here, then open the task directly.

Sign in for Project work

INDUSTRIAL REFRIGERATION · R717

R717 / Ammonia Cycle Analyzer & P‑h Diagram

Extend ammonia field P‑T and SH/SC into a bounded full-state single-stage cycle with explicit source provenance, COP, mass-flow relationships and pressure–enthalpy visualization.

Free calculator — authorized account required

Create or sign in to your free professional account. Calculator access is activated only after the applicable Leal approval policy is satisfied; engineering method and reference content remain visible.

Sign inCreate account
OEM compressor performance map →R717 thermosiphon oil cooling →OEM compressor envelope review →R717 field P‑T →R717 field diagnostics →R717 two-stage flash intercooler →R717 pumped-liquid / recirculation →Compare R717 architectures →Advanced cycle comparison →Advanced P-h workspace →Other refrigerant cycles →
WHEN TO USE THIS TOOL

Useful during reference & conversion work.

  • Resolve unit-system differences quickly across calculations, drawings, schedules and vendor data.
  • Look up common formulas, constants and engineering reminders without leaving the HVACR workspace.
  • Reduce repeated manual conversion work while keeping the final engineering review with the user.
CONTINUE IN HVACR STUDIO
Browse all tools →
R717 Two-Stage Flash Intercooler

Analyze a bounded industrial-ammonia two-stage flash-intercooler cycle with vessel mass balance, stage duties, COP and P-h schematic.

Open tool →Design vs Field Refrigeration Performance

Compare a refrigeration design cycle with stabilized field pressures, temperatures, SH/SC and optional measured capacity/compressor input while keeping model and measurement boundaries explicit.

Open tool →OEM Compressor Envelope Review

Check a refrigeration compressor operating point against an engineer-entered OEM envelope polygon with source provenance and optional declared limits.

Open tool →

Frequently asked questions

Does this replace the existing R717 P-T source?

No. Field P-T remains based on the Gao et al. vapor-pressure ancillary. This cycle tool uses a separately versioned CoolProp 8.0.0 full-state grid and records cross-source saturation-pressure agreement.

Is this an ammonia plant design tool?

No. It is a bounded dry-suction single-stage thermodynamic cycle. Machinery-room, relief, ventilation, detection, piping/vessel, exposure, oil-management and operating procedures remain separate.

Does it support two-stage or pumped ammonia?

Not inside this single-stage model. HVACR Studio now provides separate dedicated two-stage flash-intercooler and pumped-liquid/recirculation workflows; economizer heat-exchanger and other advanced architectures remain separate.

Does theoretical COP equal plant COP?

No. Compressor motor losses, oil, fans, pumps, controls, pressure drops, heat gains and actual compressor maps are outside this theoretical refrigerant-cycle model.

R717 / Ammonia Cycle Analyzer & P-h Diagram | HVACR Studio by LEAL